1. The washing machine should be placed in a clean, dry and non-corrosive atmosphere and in the environment, and avoid severe vibration.
2. There should be enough space for heat dissipation on the back of the generator.
3. Make sure the machine is well grounded to avoid personal injury.
4. Do not immerse your fingers in the cleaning solution while the washer is working.
5. It is strictly forbidden to turn on the machine under no-load condition. Before starting the machine, the cleaning liquid must be poured into the cleaning tank according to the liquid level of the instructions.
6. The object to be cleaned must not come into contact with the bottom of the tank. It is recommended to put the workpiece into the basket for cleaning.
7. The temperature of the cleaning solution will increase with continuous working time, and the continuous working time of the cleaning machine should not exceed 8 hours.
8. The cleaning solution should not be strong acid or strong alkaline. In the absence of reliable safety measures, flammable solutions cannot be used.
9. If it is found that there is water leakage in the cleaning tank, immediately shut down and stop, and empty the cleaning solution and contact the seller.
10. Â Â Â Â Â Â Â Â Â Â Â After the cleaning of the washing machine with the heating device, the heater must be turned off before the cleaning liquid is cooled and the cleaning liquid is emptied.
Normal working steps:
1. Check whether the power supply is normal, whether the switch is normal, the indicator light, and the indicator table are normal, and the cleaning slot is clean.
2. Put the cleaning liquid into the working power supply, observe whether the current indicating meter reading is between 80-100 , the cleaning liquid temperature is between 40-60 degrees, and there will be small bubbles in the colleague's sink accompanied by “å±,å±â€ The sound, which means normal cleaning begins.
3. Insulated gloves must be worn during ultrasonic cleaning.
4. Cleaning objects should not be placed directly on the bottom of the tank to avoid affecting the cleaning effect. They should be placed in a special cleaning basket or in a zero-load method.
5. The height of the cleaning solution will also affect the cleaning quality. The cleaning position of different objects should be explored at its optimum position (Note: the volume ratio of cleaning solution to cleaning tank is 3/4 ).
6. Do not switch on when there is no cleaning fluid in the cylinder to avoid damage to the transducer.
7. When not in use for a long time, the machine should be kept in a dry place.
8. The workpiece tray is placed in an ultrasonic cleaning tank for liquid cleaning.
9. Working time is 1-2 minutes, manual cleaning - gently clean the surface of the workpiece with a tool (nylon brush) to ensure that the surface and inner hole of the workpiece are clean. (Note: If there are impurities in the hole, spray it with a high-pressure air gun, and then Put it in the cleaning solution for cleaning).
10. Â Â Â Â Â Â Â Â Â Â Â Prevent the workpiece from scratching the surface and losing during the cleaning process to ensure the integrity of the workpiece.
Digital Safe,Digital Safe Box,Small Digital Safe,Electronic Digital Safe
Ningbo Reliance Security Technology CO.,Ltd , https://www.reliancesafes.com