After wheat is harvested, how to keep idle wheat combine harvesters is a matter of common concern to the owners. Here, provide some custody knowledge. 1. Open the lid and shield on the combine harvester to thoroughly clean the inside and outside dust, wheat straw, wheat straw and weeds on the machine. 2. Drive into the garage to release oil and cooling water. The new lubricant was dehydrated (heated to 110-150°C until the foam disappeared). Then crank the crankshaft a few times to fill the entire lubrication system. Then use a plastic cloth to wrap the air filter, the vent nozzle, the tank cap, and the fuel tank cap. 3. Put the header on the wheat combine harvester on the pre-prepared wood, lift the axle with the jack, support the cushion, and allow the tire to leave the ground. In order to reduce the inner tire pressure tire pressure, tire pressure should be put to 0.05 MPa. 4, remove all the belt (triangle belt), after technical appraisal, can still be used, to clean, coated with talcum powder, tied to the label, stored in a cool dry place. If you want to hang it on the wall, try not to let the belt roll. 5. Remove the wood bush from the drive chain and the document drafter. After washing the sludge, dig out the sticky oil and put it in the engine oil and soak it in the engine oil for 20-30 minutes. Soak it out for 20-30 minutes. The engine oil that adheres to it is dripped and then wrapped with kraft paper or plastic cloth and stored in a ventilated and dry room. 6. According to the lubrication chart, grease the grease points with a grease gun to lubricate all parts of the wheat harvester. 7. Remove the battery and store it separately. Charge it once a month during storage. After cleaning, clean the electrodes and apply FanTulin. 8. Replace worn and damaged parts. Nothing can be replaced at a time, be marked, and be replaced before the next year's operation. 9, on the paint off the site, do a good job of oil rust treatment.
Importance: 1. Bottle should be used within 60 days of first opening. 2. Keep away from light and moisture. 3. Do not leave in the bathroom to avoid moisture. 4. Tightly replace cap after removing strips from the bottle. 5. Do not remove desiccants or touch test areas. 6. Use within expiration date. Reading the results: Negative: reduce carbohydrates intake or increase excercise. Trace/ small/ moderate: your health is satisfactory and you are burning fat. Large: increase carbohydrates or reduce exercise.
Urine Test Strips Cvs,Home Urine Test Strips,Negative Uti Test Strip,Urine Test Strips For Ovulation
Changchun LYZ Technology Co., Ltd , https://www.lyzstrips.com